Search models, users, collections, and posts
AD5X mount for front facing IFS
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
2.7 h
2 plates
Open in Bambu Studio
Boost
24
38
3
0
33
0
Released
Description
My Flashforge AD5X setup called for a front facing IFS mount to be inline with my dryer box. Nothing was quite matching what I needed, so I designed one in tinkercad. Once installed, it was clear that the IFS cable needed to shift to connect back to the IFS. I created the new horizontal IFS cable clip that allows enough slack for this to happen. Both of these use the screws included with the existing AD5X setup.
Settings for my print:
- PLA
- .20mm layer height
- 20% Infill
- Supports on
If interested, here are the links to the dryer box and the additional PTFE tube and fittings.
Dryer: https://a.co/d/0e37iFX3
Tubing and fittings: https://a.co/d/0fTRAOg2
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (3)