Commemorative and Remembrance Soldier Series

Commemorative and Remembrance Soldier Series

A global tribute collection honouring service and sacrifice across all nations.

This series features three detailed soldier statues created as a global tribute to all who served, regardless of nation or era. Each figure is sculpted with care, capturing the quiet strength, discipline, and humanity of soldiers throughout history.

Included in this collection:

• Rifle Rest – a calm, grounded stance symbolising vigilance and duty.
• Bugler – the timeless call to remembrance, recognised across all nations.
• Shoulder Arms – a traditional drill posture representing readiness and respect.

Each statue prints as a single piece on a standard build plate and displays beautifully in black PLA, bronze‑tone filaments, or matte finishes.

Created as part of an ongoing effort to honour service and sacrifice worldwide.

These models are optimised for tree supports and print cleanly on most printers.

N.M.P Designs.

This project uses the default Bambu Lab 0.12 mm Fine preset. Only the following settings have been adjusted for improved stability on detailed statue models:

Quality

• Seam Position: Back

Strength

• Wall Loops: 3
• Top Shell Layers: 5
• Bottom Shell Layers: 5

Supports (Tree)

• Support Type: Tree
• Threshold Angle: 50°
• Top Z Distance: 0.22 mm
• Bottom Z Distance: 0.22 mm
• Branch Distance: 4.0 mm
• Branch Diameter: 2.8 mm
• Branch Angle: 35°

Other

• Brim Type: Outer Brim Only
• Brim Width: 7 mm
• Brim Object Gap: 0 mm

Support Removal Note

These models contain fine details, including straps, slings, and small objects. Tree supports are intentionally snug to protect these areas during printing, and some branches may require a little extra effort to remove — this is by design.

Take your time when removing supports:

• A good pair of snips is highly recommended
• Work slowly around straps, slings, and gear
• Apply gentle pressure and peel supports away in small sections

With a bit of patience, supports will come off cleanly without damaging the model.

Everything Else

All other settings remain default from the Bambu Lab 0.12 mm Fine preset.

For best adhesion, print on a clean build plate. If your plate is worn or has fingerprints, apply a light glue‑stick layer.