Print Profile(2)
Bill of Materials
- Mutter M6 x 1: Rostfrei
- Schraube M6x30 x 1: Rostfrei
Description
Sailboat Wind Chime
This is a wind chime with two sailboats
(optionally also with 4 sailboats => see separate print profile for 4-head)
Ball bearings are installed in the wind chime (see parts list) so that the wind chime runs even in light wind (there was little wind in the video)
The sails with mast can rotate, allowing the boats to "tack" as they pass through the wind, thus driving the wind chime
Screws are used for assembly, no glue is necessary, see Assembly Instructions
The print profile is set for multiple colors on several plates
Please ensure that the printer and filament are well calibrated so that the bearing fits are printed cleanly Also, due to overhangs on the hull, printing should be done with a layer height of 0.16mm
Due to UV resistance, I recommend printing in PETG or PETG-HF
Additionally required parts:
8 pcs screws M2.5x6
1 pc screw M6x30 with nut
Bearings OD x ID x Width:
2 pcs 24x8x8
4 pcs 16x8x5
Have fun
Feel free to check out my Darrieus wind chime as well: https://makerworld.com/en/models/677318-vertical-wind-turbine-darrieus#profileId-1548045
Boost Me (for free)
If you like the design, I appreciate a 'boost me'
Membership
By signing up as a member, you receive permission to use physical prints of my models for commercial purposes.
© Staprin3D
Documentation (1)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (14)