Ubiquiti UniFi USW-Pro-XG-8 Minimal Cooling Feet

Minimalist standoff feet designed specifically for the Ubiquiti UniFi USW-Pro-XG-10POE (and other UniFi switches with the standard 13x13mm square bottom mounts).

These feet are engineered to snap directly into the recessed square holes on the bottom of the chassis, providing a secure and stable fit without the need for adhesives.

Key Features:

• Plug & Play: Precise 12.8mm x 12.8mm insert for a perfect fit.
• Improved Cooling: Lifts the switch by [inserisci qui l'altezza in mm] mm to allow maximum airflow underneath the metal chassis.

• Heat Management: Crucial for XG models that tend to run hot under 10GbE / PoE++ loads.

   

Printing Recommendations (Piè di pagina / Note)

• Material: PETG, ASA, or ABS is highly recommended. The Pro-XG-6POE chassis can reach high temperatures that might soften or deform standard PLA over time.
• Wall Count: Use at least 3-4 walls for structural strength on the mounting plug.
• Infill: 15% (Gyroid or Grid).
• No Supports Needed: Print with the plug facing upwards.

"Designed for a clean, professional desktop setup."