Search models, users, collections, and posts
Demarcation Stud
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
25 min
1 plate
Open in Bambu Studio
Boost
1
0
0
0
0
0
Released
Description
I wanted to mark out some parking bays on the driveway without painting lines etc and this seemed like a good solution.
I've printed on Sunlu PLA+ and was able to tap them in with a hammer ok (a couple did start to crack but not a problem) and have had them in situ for a few months now without issue. I'm planning them to print in glow in the dark filament.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)