Wire Stripper - Insulation remover V2

Since I did not have any blades to suit the other designs out there, naturally I had to design my own that uses a 'OLFA' snappable blade... so when your stripper inevitably snaps off the tip of the blade, you can simply snap a new section off, use the screw thread to push the next section into position and continue, without needing to totally reset your stripping workspace.

You will need:

3x CS M6 12mm Bolts (or longer)
1x M5 Nut  
1x M5 0.8mm thread DIE (for cutting the thread on the long bit)
1x OLFA blade
1x bench vice to use for stripping

I designed it to strip 10mm double-insulated cable... I will also design/add/upload a smaller size guide when I need it but I've also added the SKP files for you to modify if you want.