Lenovo ThinkCentre Tiny — 10" Rack Mount

If you like the model, a like or comment means a lot 😊 Got feedback or ideas? Feel free to drop a comment or reach out directly — always happy to hear it.

Lenovo ThinkCentre Tiny — 10" Rack Mount

Building out my homelab on a 10" rack — wanted a consistent, clean aesthetic across all my mounts so I designed my own. The bracket has vent holes on the side aligned with the ThinkCentre Tiny chassis vents to keep airflow unobstructed.

Compatibility

• M710q✓
• M910q✓
• M910x✓
• P320✓
• M630e✓
• M720q ✓
• M920q ✓
• M920x ✓
• P330 ✓
• M75q✓  (chassis is identical to Intel Tiny models)
• M60e✓ (Confirmed in comments)
• M70q (Have same body as M60e by images)
• M80q (Have same body as M60e by images)
• M90q (Have same body as M60e by images)

Many other Tiny models share the same chassis dimensions and may fit — if you try one, let me know in the comments!

Variants

Two models available:

• Rear retention lip — keeps the Tiny secured from the back
• Lockable rear backpanel — fully encloses the rear with a lockable panel
• Both include 3mm and 4mm front panel thickness as separate plates in the print profile.

Print settings

• Material: PETG recommended or higher to avoid heat deformation
• Layer height: 0.2mm
• Infill: 10% Gyroid or higher for sides
• Front panel: 25% Gyroid infill, 4 walls, 4/6 bottom/top layers (modifier included in 3MF)
• PETG on smooth PEI: use a release agent like hairspray or glue stick to protect your plate
• Heatset inserts: M3x5x4.5 required for the lockable rear backpanel version

Installation

Slide the ThinkCentre into the bracket and mount to your 10" rack using standard rack screws.

Changelog

5/3/2026

• Reduced amount of mounting holes 6→4
• Made holes smaller 7.5mm→6.5mm since 7.5mm is quite big for M5 screws, so 6.5mm suits well for both. (Tested with KWS and LabRax)