GH1200 Glue Multiboard Holder

GH1200 Glue Holder for Multiboard

I had a couple bottles of GH1200 CA glue, and wanted a way to attach them to my Multiboard on my printer. This holds very securely

In this is included 8 versions: 

• holders that are press-fit into the Multiboard
• holders that use bolt-lock to attach to the Multiboard
• versions of both where you can have the attachment points on either the top or bottom of the holder's back
• a single- and double-slot version of all of these options! 

The weight for the project in total is 101g of PLA, but that's for all 8 models. The weights are approximately 15g for the double bottle models, and approximately 10g for the single bottle models, including supports 

How to Attach

Heavy Weight-Bearing Snaps: https://than.gs/m/1311032

Moderate Weight-Bearing Snaps: https://than.gs/m/1311034 

Folded Locking Bolt: https://than.gs/m/1310061 

Recommended Print Settings

I printed this in 0.2mm layer height, 15% infill, and 3 walls. Any print height should do though, as I tested up to 0.24mm. Lower layer heights do make for a better finish and fit though

Supports are only required on the top-aligned versions of this project

LICENSING: You may not use this design or file for commercial purposes. See Full License Here: 

https://www.multiboard.io/license
Creative Commons - Attribution - Non-Commercial - Share Alike

Original Designer: https://www.multiboard.io/parts-library