Search models, users, collections, and posts
ReveD RDX Diffuser
IP Report
Print Profile(2)
0.08mm layer, 2 walls, 15% infill
Designer
3.7 h
1 plate
0.08mm layer, 2 walls, 15% infill
Designer
4.8 h
2 plates
Open in Bambu Studio
Boost
11
15
0
0
9
5
Released
Description
Content has been automatically translated.
RC drift car modification. No worries about it scraping if mounted too low, as it's designed with an angle. Compatible with all chassis plates that share the original RDX's hole positions. No high infill density or supports required. Screws/nuts are needed. Direct screwing is not supported, as direct-screw versions are prone to hole breakage upon impact due to printing characteristics.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)