Ground Effect Aircraft - Monster T1

Catalog => <Warship-Ship>-<Fighter-Aircraft>-<Vehicle-Tank>-<Aerospace>-<Miniature>-<Mecha>-<Weapon>-<Uncategorized>

Ground Effect Aircraft - Monster T1

Ground Effect Aircraft - Monster T1

This is a highly detailed model, optimized for easy printing. This model has been specifically optimized for 3D printing.
Printing Tips:
Print Bed: Use a textured PEI sheet.
Filament: PLA
Layer Height: 0.12mm
Outer Wall Count: 2
Acceleration: Set all acceleration values to 1000 mm/s² or lower.
Important Notes:
Some sanding and gluing may be required due to material shrinkage and printing tolerances. Apply even pressure when assembling parts.
Before printing, thoroughly clean the PEI print bed to ensure good adhesion, and ensure your filament is dry.
Special thanks to all friends for your attention, likes, downloads, and support!

============================================================================

Single cockpit, movable wings and canopy, glue required for assembly.

placed and taken out.

Printing Tips:

Print Bed: Use a textured PEI sheet.

Material: PLA

Layer Height: 0.12mm

Outer Wall Count: 2

Acceleration: Set all acceleration values to 1000 mm/s² or lower.

Important Notes:

Some sanding and gluing may be required due to material shrinkage and printing tolerances. Apply even pressure when assembling parts.

Before printing, thoroughly clean the PEI print bed to ensure good adhesion, and ensure your material is dry.

Special thanks to all friends for your attention, likes, downloads, and support!