Search models, users, collections, and posts
Honda Element Rear Emblem
IP Report
Print Profile(1)
0.2mm layer, 4 walls, 25% infill
Designer
27 min
1 plate
Open in Bambu Studio
Boost
6
10
3
0
15
3
Released
Description
The “Element” rear emblem of my little toaster car broke off. Rather than search high and low for this fragile and overpriced part, I made a replacement in Onshape. I'd say it's pretty close.
I wouldn't recommend printing in PLA due to how hot the surface of the car gets.
I printed it in PETG in black since I painted my Honda logo black. It looks somewhat passable in silver PETG as well, but it would probably be best to spray it with Rust-olem Mirror finish to make it look chromed out. I affixed it to my car with e6000 adhesive since I was out of rubber cement, it's holding up just fine.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)