Adjustable Garden Sprinkler for grass lawn

Adjustable garden sprinkler with different heads. 

No glue required. Adjusting the head changes the dynamic of the sprinkler, with the cone screwed in it becomes a water saving fine flow, wind out the screw cap and it becomes a wide angle soaking heavier spray. Water pressure dependant of course, but I am getting 3meters either side of the sprinkler. This came about because I wanted something quick to print that I could adjust and that did not have a ground spike.

You will need;
1 x hosepipe rubber seal (take it from any other hosepipe accessory) 
1 x european style ¾ inch threaded end (or print one, dont forget the o-ring) like the below image
 

Print:

Print the sprinkler
Print the non lawn damaging stand

Print 1 x top cap of your choice (only makes a difference when screwed in tighter for water saving spray)

Assemble:

Remove Supports
Place rubber washer inside threaded section
Screw in ¾ adapter
Screw on printed top cap

Screw in base

Set and Use:
Hold in hand pointing away from you (unless you like being wet…), turn on hose, adjust top cap to meet requirements. Turn off hose and place on grass. Turn on hose, get a beer.