Enhauto SEXY Dash Mount

Enhauto SEXY Dash Mount – Steering Wheel Wireless Charger Cover Edition

This mount lets you install the Enhauto SEXY Dash using the plastic cover bracket from a steering wheel column wireless charger looking like the image below.
 

What you need:

• The plastic cover/bracket from a steering wheel wireless charger (like the common 15W steering column chargers sold on Amazon, AliExpress, Fruugo etc.)
• The two screws that that came included with the steering wheel wireless charger
• The magnet mount that came included with your Enhauto SEXY Dash
• The hex bolt and nut that came included with your Enhauto SEXY Dash

How it works: 

I would recommend to route the charging cable through the bracket and mount before assembly.

1. The printed part slides into the charger bracket housing and uses the two screws that came included with the steering wheel wireless charger.
   

    

2. Mount the magnet with the pivot bolt and nut that came with the SEXY Dash (do not tighten the bolt fully at this point).
   

3. Mount the cover in your car according to the instructions for the wireless charger.

    

4. Adjust the magnet to your preferred tilt angle and thighten the bolt.

    

5. Done! :)

No drilling, no glue, no permanent modifications.

What's included in this print profile:

• Mount bracket

Print settings:

• Material: PETG, ASA or ABS recommended (heat resistance matters in a car cabin)
• Supports: Yes (where needed)
• Infill: 25% or more