Duck Slide diorama no batteries
Print Profile(5)
Description
This is quite fun and very easy to print The propeller is not necessary; simply with the slide pool and the screw, turning it manually will make it work, even if you do it very slowly The large base piece of the slide does not require supports or infill at most, some support might be needed under the highest part of the slide but it is not even essential Removing any remaining strings usually saves material Use 2 walls and no infill; this way, water will drain properly from inside the walls The base has no interior, only exterior walls, and neither does the structure
The other parts include an Archimedes screw that will raise the water and a propeller to move it with wind or by hand
It works at any speed
I hope you like this fun design regards
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)