Breathable TPU Lift Insoles (2 to X mm)

Insoles to increase support in your shoe (ski, snowboard, walking, running).

Print time: 

• Between 3h and 8h for both insoles depending on shoe size and thickness

Information: 

The insole is designed to be flexible and adapt to all shoe sizes. 

It should be placed under your insole, with the upper side facing the bottom of the shoe.

The insole can be cut for a perfect fit (do not exceed the designated cutting area, approximately 8 mm around).

Profile details: 

• TPU 95A printing recommended or other flexible filament (no PLA / PETG or other hard plastic)
• one profile for each shoe size (from 35 to 48 EU / CN - 2.5 to 12.5 UK - 5 to 13 US - feet from 22 to 31 cm)
• each profile is provided with 2,3,4 and 5mm thicknesses. You can increase the thickness if you wish.
• download the profile corresponding to your shoe size and print the 2 plates corresponding to the desired thickness.
• the insoles print upside down, with the upper side against the build plate

Instructions for use: 

• slip under your insole, do not make contact with the foot
• the side against the build plate is the upper side (intended to be in contact with your insole)
• the underside has asperities to increase adhesion to the bottom of your shoe
• if the insole is too large, use your current insole to mark excess areas and cut. Do not exceed the designated cutting area (solid area around the insole)

Uses:

• ideal for ski or snowboard boot liners if the liner compresses a bit
• if your shoe is a bit too large
• if you want better support

Thank you for your future feedback.