Nokia 3310 Bic Lighter Case

Nokia 3310 Bic Lighter Case. Prints horizontal WITHOUT supports, Has little waste in under 2 hours. Fits my standard Bic lighter although lighter sizes my vary. Lighter can be pushed out from bottom hole if too tight to pull out by hand. Lighters with sticker or a graphic wrap might not fit.

Do not use supports.

In order to print this on its side without supports there may be some filament that as it spans the inside top of the lighter slot sags a bit and will have to be removed. I recommend just using one side of a pair of scissors to scrape any loose debris.