Search models, users, collections, and posts
25L Drum Cap
IP Report
Print Profile(1)
0.16mm layer, 3 walls, 25% infill
Designer
3.8 h
2 plates
Open in Bambu Studio
Boost
0
3
0
0
4
5
Released
Description
This is a cap / lid for a 25L methylated spirits drum though I believe these are pretty universal. It uses a 2" BSP thread and you can screw it down by hand, I created this so I could have a cap with a hole in it + a vent for a diesel tank for my workshop diesel heater, though I've also provided a blank one.
Preferably print with PETG, ABS is ok as well for diesel which is what I used. If you are storing something other than diesel make sure you use a filament that is compatible.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)