Search models, users, collections, and posts
Echo Dot 4th & 5th Gen Upright Wall Mount V5
IP Report
Print Profile(5)
FLAT WALL VERSION UPDATED - 02/14/25
Designer
1.1 h
1 plate
Back plate for mounting with tape or epoxy
Designer
1.2 h
1 plate
PLA with manual supports
3.7 h
4 plates
0.2mm layer, 3 walls, 15% infill PETG
2 h
1 plate
Click to see more
Open in Bambu Studio
Boost
158
510
126
65
1.1 k
831
Released
Description
I made this after buying a echo dot 5th gen with clock. My old mounts would have the echo's face downwards allowing for easy access to the buttons but with this model that wasn't going to work, instead of buying a new mount I decided to make one.
this features slots at the bottom so the LED ring can shine through
Pass-Through Install
M4.5 (5/32in) screws are recommended for mounting. 20mm(3/4in) length should be plenty depending on your anchoring system.
If your anchor requires the screw to go further in to fully engage, purchase new ones and add 10mm(3/8in) from your original screw length.
Plate install
Use double sided tape or epoxy to install this version.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (126)