Valorant Reaver Gaia, No AMS, Light-Up

Valorant Vandal Gaia Light-up

If you don't need the weapon to light up, you can also print the parts and complete the assembly

Commercial use in any form is prohibited without the author's permission For any form of reproduction, please credit the author and provide the source, thank you

Printing filament:

1 Bambu Lab PLA Matte Bone White

2 Bambu Lab PETG Translucent Red

Other materials:

1 Bambu Lab Rechargeable Power Kit ZC003

2 One COB LED strip (5V, 5mm wide, 1m long)

3 One terminal wire (2-pin ZH1.5mm, 100mm long)

4 COB LED strip solderless connector (5mm wide, two-wire single-head connection)

5 Several LED no-strip wiring terminal strip quick connectors or waterproof terminal solder rings

6 Glue

See the attached BOM table for details, which contains a detailed procurement list

The COB LED strip needs to be connected to the 2-pin terminal wire using the LED strip connector and then wrapped with heat shrink tubing before use

Engineering drawings:

Installation instructions:

When installing the COB LED beads, please pay attention to the installation sequence of the light slots When installing the handguard (the part with the circuit board) and the receiver (the part with the red gem charging handle), both COB strips on both sides should first be installed in place, leaving a certain length of LED beads, then tighten the COB wires on both sides, secure the parts, and finally slowly slide the parts into their corresponding mounting positions Additionally, when installing the front LED beads, the COB must pass through parts 1, 2, and 3 in the order shown in Figure 3, otherwise, it cannot be installed correctly