Flik parts - Complete set for FlyingRC F405 wing
Print Profile(1)
Description
This is my setup for the Flik
https://epicfpv.ca/products/alight-wing-flik-mini-fpv-airframe-kit?srsltid=AfmBOooFEfAe4T4Ahh3AsRlroQLNPnttkeypu8WRXS6jdsYPmyow6wf0
Only the front camera mount is printed using TPU, otherwise all in PLA.
All parts are held in place using E6000 glue.
The flight controller is a FlyingRC F405 sold on Aliexpress for about $20 CAD.
GPS is a FlyWoo nano
A couple parts are remixed from nclncl
Check out his creations here: https://www.thingiverse.com/nclncl/designs
Description of the parts:
Battery tray: My setup is for a 6S 650mah but should work for many others
Canopy Latch: Printed this https://www.thingiverse.com/thing:7015056 but it ends up loose, so I added this part to the fuselage to make it tighter.
FC_bottom: It's a remix and added the original holder for the Flying RC FC
GPS: Again a remix and then modded to hold the FlyWoo GPS
O4 25x25 front support: This allows you to add the AirUnit in the front as far forward as possible. You can glue nylon M2 screws onto the stubs.
O4 lite support: It holds the camera perfectly in place in the front.
Wire_Management: Simple piece to manage the wires in the back.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (4)