My Tanq 2 5inch parts
Print Profile(1)
Description
Three parts here..
The original dual antenna mount, but adapted to fill the entire height, and fit o4 pro antennas.
A GPS mount. I use the FlyWoo nano. Note that it's held by using slightly longer rear screws and some B7000 or similar glue. There is a 30 degree angle for the GPS so it's relatively flat when flying.
A 40 degree adapter for the O4 pro camera. I really couldn't stand the HUGE mount they provide or the STL they provide, and the top they go is 15 degrees, so I made this one that doesn't stand out as much. Note that the second screw holding the camera is hidden and much shorter. You can use the original O4 camera screw for that. Then you need a 10mm screw for the second screw as it feeds outside the frame. Also note that the sencond lateral standoff must be removed. Some may not like this, but I found it overkill.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)