Search models, users, collections, and posts
Bending device for the vise
IP Report
Print Profile(1)
0.2mm layer, 7 walls, 25% infill
Designer
4.7 h
1 plate
Open in Bambu Studio
Boost
275
1048
8
2
141
84
Released
Description
Content has been automatically translated.
Bending punch and die for a vice with 125mm jaw width and 25mm jaw height
5x3mm magnets can be glued into the back
The angle is 87° allowing 90° angles to be bent without problems or springback
The punch is also robust enough at this angle The die width is 15mm and the edge radius of both the die and the punch is 1mm
Printed in PLA this bending device works very well
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)