Search models, users, collections, and posts
Segway Ninebot G30LP Rear Axle Cap
IP Report
Print Profile(1)
0.2mm layer, 5 walls, 15% infill
Designer
4.5 h
2 plates
Open in Bambu Studio
Boost
6
10
0
0
5
3
Released
Description
I designed this rear axle cap for the Segway Ninebot G30LP to clean up the look of the rear wheel arm area.
The version shown in the photos is printed in blue and yellow.
This model is intended for the G30LP. Other Ninebot models have not been tested, so treat this as G30LP-specific unless you confirm fitment yourself.
PETG is min requirement for heat and weather resistance
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)