Pegboard Pegs, Hangers and Pegboard Strips

I Love the pegs the original creator made, and the different attachments.

but the peg to hold the attachments did not fit my Lowes pegboard right,

So i altered the peg to fit my pegboard.

The first peg i made fit my pegboard with slightly more spacing from the wall but too 

long to fit my other pegboard so made a shorter version. So 2 peg versions included, 

Now i can use the altered pegs, with the original attachments.

I also sliced off the hanging part of the attachments so can glue to 3d printed trays,

then can hang trays on the pegboard. I decided glue on would be better, so adaptable to

different size trays. 

Then i made strips with the rings and the hooks also. 

To Glue, Hang 2 pegs on the pegboard, spacing so fits the tray using, 

then put the glue on the (back) flat part at the bottom of 2 hangers,

Hang the hangers on the pegs, 

and press the tray to the glue where want it positioned for 30 seconds.

I hold one finger on top of  each peg so hanger dont move when pressing the tray on.

then holding the tray to the hangers remove off the pegboard and 

clamp for 10 minutes to make sure the glue is set.

If the hanger moves on the glue when pulling it off the pegboard redo so positioned right, 

After the first one, it gets easy. 

Being able to glue the hangers on, opens it up so can use whatever trays, etc

you want off makerworld. License: use the original designers license.