Another Training Karambit

After the great reception of my previous model, Training Karambit – Field-Tested Practice Knife, I decided to create this one.

Straight out of a CS vibe — but safe IRL. Perfect for spins, fidgeting, and desk flexing without sending anyone back to spawn.

Assembly is simple: just press the pins in. No glue needed if your tolerances are on point (worked perfectly for me), but you can add it if you want a permanent build.

Disclaimer:

This model is intended for training and decorative purposes.
It is not a real weapon, but due to the thin edge, proper handling is required.

☕ If you like this model, you can support me here:

🛠️Before You Start Printing

Before printing, give the bed a quick clean 🧽 — good adhesion = better first layer and accurate geometry.

Use dry filament (wet filament loves to pop, string, and ruin dimensions).

When using my MakerWorld profiles, make sure the selected material matches what you’re actually printing. Different materials shrink and behave differently — the wrong profile can mean wrong dimensions.

Also, my STL files are designed and dimensioned for PLA. If you print them in PETG, you may need to slightly rescale the model to compensate for different shrinkage.

Clean bed. Dry filament. Correct material. Done 😄