PTS EPM-MTW Anti-Tilt Follower (Wolverine)

Stop your PTS EPM-MTW feeding nightmares!

This custom follower is the ultimate mechanical fix for the Wolverine MTW / PTS EPM-MTW magazine feeding issues. If you own a Forged or Billet MTW and use these magazines, you know the struggle: jams, mid-cap syndrome with heavy BBs, and the "Empty Mag Detection" failing to work.

What this part solves: By replacing the original orange follower with this extended guide design, you can finally:

• Load to the Max: Fill your magazines to their full capacity without fear. No more leaving them half-empty to avoid jams.
• Zero Jams: The extended "Anti-Tilt" ribs prevent the follower from twisting or locking up inside the channel.
• Reliable Cut-off: Maintains 100% functionality of the Empty Mag Detection. Your MTW will stop firing exactly when it should.
• Heavy BB Ready: Tested and perfected for 0.32g BBs and high ROF (tested at 21 RPS).

Installation: It’s a direct "drop-in" replacement. Simply open your magazine, swap the original orange piece for this one, and you are good to go. Forget about feeding failures forever!

Recommended Print Settings:

• Material: ASA or ABS (Mandatory for low friction and durability).
• Nozzle: 0.4 mm (Standard).
• Layer Height: 0.20 mm (Perfect balance between strength and detail).
• Walls: 4+ (Ensure the top part is solid to engage the bolt-stop).
• Infill: 100% Solid.
• Support: No supports needed if printed standing up.
• Orientation: Print vertically for maximum structural integrity.

I recommend using a tiny bit of dry PTFE or Graphite lubricant on the follower ribs for the smoothest experience. Avoid liquid oils as they attract dirt.