Holder for SyRen 10A Dimension Engineering

Designed for the SyRen 10A motor driver from Dimension Engineering, this holder provides a clean, compact, and service-friendly mounting solution for robotics and custom electronics builds. I created it for my R2D2 project, where I needed a simple way to mount the controller securely while keeping it easy to access for wiring and maintenance.

The design uses an X-shaped rear support to hold the SyRen 10A firmly in place without adding unnecessary bulk. It keeps the board secure while leaving the terminals, switches, and main areas of the controller accessible. That makes installation cleaner and more practical inside a droid, robot, or other custom electronics project.

For assembly, I used:

• 4x heat-set threaded inserts, OD 4.5 mm, H 3 mm
• 4x M3 x 6 mm screws

The holder itself can simply be glued onto any flat surface, which makes installation quick and easy inside a chassis, electronics bay, or internal panel. If maintenance is needed later, you can just unscrew the controller from the holder without removing the whole support, which makes servicing and replacement much easier.

This is a functional mount for builders using the SyRen 10A in a droid, robot, RC platform, animatronic, or motion-control project. It is especially useful when you want a lightweight, compact, and easy-to-service mounting solution instead of a bulky enclosure.

I designed it from real-world use inside my R2D2, with the goal of getting a tidy internal layout, reliable retention, and fast installation with minimal material.