Right-angle Aquarium Hideout - Landscaping Simulated Roman Columns - Underground Palace Cave - Interlocking Structure

The original model size is approximately 20cm long * 20cm wide * 10cm high, with a side wall thickness of 3mm and top and bottom thickness of 4mm

Printed on three plates, the main body size can be adjusted as needed, only the pillars require support, saving a lot of material

It is recommended that if the Roman columns need to be scaled down, only adjust the height, as a smaller diameter will affect the printing effect; if scaling up, the entire model can be scaled up

The Roman column plate can be attempted with 0.2 printing; the picture shows 0.4, which still feels a bit rough

Grey prints turn out a bit dark, it is recommended to print in white or PLA Marble (feel free to share your prints!)

The photo shows a missing corner design because I needed to add a pipe in this corner; the uploaded model has a perfect right angle, which is more aesthetically pleasing

——

It is recommended to fill with water only after it is fully assembled

If assembling underwater, it is recommended to first install the pillars on the base; after submerging, cut off 7-8 top connections of the pillars, keeping 2-3 is sufficient to reduce the difficulty of installing the top cover, and water can be filled into the pillars to increase the model's weight

——

There is a personal logo on the model surface, but it will be covered by sand during actual use, so no worries

Suggestions for model improvements are welcome~~~