Minecraft Armor Stand Tech Charger

READ THIS BEFORE YOU PRINT!!!

You will not need every plate, only the ones for the electronics you have.

Instructions:

Before you do any printing, look at your electronics.

For the earbuds (aka boots), you only need the case for the earbuds you have. Note: these chargers do not work if you have a case for your earbuds.

For the watch (aka leggings), you only need the holder for the watch you have (if you don't have a watch then you don't need to print the holder)

Alright, go print it now, but MAKE SURE YOU COME BACK AFTER! You still have to assemble the armor stand and put the armor on.

After-print instructions:

Grab the base and the 2 long legs. Put the pegs in the holes in the base and add a little glue.

Next, grab the holder piece with the long clip and align the pegs with the holes on the long leg pieces from the last step, and add a little glue.

Next, grab the 2 short chest pieces. Put the pegs into the holes on the last piece and add a little glue.

Grab the big shoulder piece and put the pegs into the holes on the chest pieces and add a little glue.

Last, grab the neck piece and put the peg into the hole on the shoulder piece, and add a little glue. 

Alright, now that you are done assembling the armor stand, put your earbuds charging case in the boots and put the boots into the little slot in the base.

Grab your charging cord at guide it through the hole in the back near the base of the boots and up through the earbud case.

Take the leggings and put your watch holder on it and set it on the holder and put your cord in the slot for it.

Put the chestplate on the holders and your little bottom in the slot for it and guide your cord through it.

Finally, put the helmet on the holders and put your cord through it.

There you go! You’re done! Have fun with your charger and thanks for printing! If you have any ideas for upgrades or want your watch or earbuds made into this, just post it in the comments with the name of the earbuds or watch.