Chinook MH 47 SPEC OPS Outfitted Variant

I remixed Lion RCs MH 47 to make it a SPEC OPS Variant by adding the fuel pole, adding a machine gun I created in Tinkercad that can be glued in, opening up the one side door for where the machine gun goes on the SPEC OPS variant, and I added another set of seats I created that you can glue inside the model where troops would sit.  I also scaled it way down to approx 300 G of filament vs the 2000 from the original model.  Awesome design by Lion RC though, I just tweaked it a bit and made it more printable filament use friendly, but if you have the filament you should 100 percent print Lion RCs original huge model. Assembly is pretty straightforward. Just look at the model pictures I took for some pieces that may be confusing as there are 2 tower looking pieces that snap into the rotar round pieces (no glue), and the tower pieces get glued into the holes on top of the chinook. That allows the rotars to spin.