Fortnite Chest - Free 3D Print Model

Search models, users, collections, and posts

blecheimer

Props & Cosplays>Other Props & Cosplays

IP Report

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

A1 mini

FN Chest - PETG for support, 0.2mm layer, 3 walls, 8% infill

Designer

4.1 h

3 plates

4.9(104)

FN chest, improved profile - 0.2mm layer, 3 walls, 8% infill

Designer

2.8 h

3 plates

4.9(39)

Faster print, a1 mini fits, extra brim added

4.7 h

2 plates

4.8(6)

Open in Bambu Studio

Boost

554

1115

180

110

1.6 k

1.3 k

Released

Description

Yes, this is the famous chest from fortnite - print it, assemble it, loot it!

The 3mf file shows my recommended orientation of the parts. There are three plates, one for each colour (yellow, light grey, dark grey). The top part of the chest needs support, I am using PETG for the support interface. All other parts are support-free. If you need a brim for the small parts depends on your filament and your bedplate. To optimize adhesion you might want to use a very thin layer of glue stick.

Assembly is straight forward. Glue everything in place. Be carefull with the hinges: Place the top part of the chest on the bottom part, then glue the hinges in place. By doing so the position of the hinges will be perfect and the lid closes without a gap. The handles do not need glue.

GG loopers!

EDIT 2025-01-31
I uploaded an alternative print profile that does not use PETG for the support interface.

Boost Me (for free)

Like it? Boost it!

If you want to support me you can leave a tip at ko-fi.com/blecheimer.

Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0. The shown model is fanart and must not be used commercially.
Copying this model to other 3D printing websites is not allowed without my permission.