Apex 5" Motor Wire Covers - ImpulceRC FPV Drone

These are simple wire covers for the ImpulseRC Apex 5", should fit regular, HD and EVO models, and many of their clones. They are made to be the exatct same size as the arms, following the original curves, so they fit nicely, while protecting the arm and motor wires.

I used B-7000 to glue them to the arms, but if you're flying very hard and crash a lot, I'd recommend also wrapping them around with electrical tape for extra durability.

3D printing settings

Can be printed on any modern FDM printer with decent cooling
No supports is crucial!
Can be printed with PLA\PETG\ABS\ASA or other rigid materials (or harder flexibles)
Designed for 0.4 nozzle, but should be printable with other sizes
Lower layer height works better, but standart 0.2mm is fine