CoinCore APEX – Modular EDC Wallet
Print Profile(8)
Bill of Materials
- Gummiband x 1: 30 mm Breite - 26 cm Länge
Description
Boost Me (for free)
If you like the model or it helped you with your project, please leave a boost! It helps us to continue investing time in high-quality designs and optimizations. Happy printing! 🛠️
The COINCORE APEX is a modular, screwless EDC wallet designed for maximum flexibility
The System & Assembly
The wallet is held together by a 30 mm wide elastic band The front of the wallet
serves as quick access for folded banknotes in any configuration
Absolutely essential material:
- Elastic band: 30 mm wide with a length of 26 cm
The wallet scales according to your needs:
- Minimalist: Outer plates only (ultra-flat cardholder)
- Single Core: Outer plates + 1 APEX Core
- Dual Core: Outer plates + 2 APEX Cores (cards are secured in the space between the cores)
Maximum Flexibility: The APEX Cores
The Cores are the functional heart of the wallet Depending on your daily situation, you swap out the core to adapt your wallet to your requirements:
- APEX Multi: Coins (1€, 2€) + Cargo compartment + Yubikey
- APEX Guardian: Cargo compartment + Yubikey
- APEX Ghost: SD & MicroSD + Cargo compartment + Yubikey
- APEX Essential: Coins (1€, 2€) + Cargo compartment
- APEX Divider: 1x large cargo compartment + 2x small cargo compartments
- APEX Cargo: Maximum open cargo storage space
Important note on fit (tolerances)
Since each filament (PLA, PETG, ASA etc) shrinks differently, the coin compartments and hardware slots may fit very tightly the first time
- First use: Don't hesitate to apply a little force when inserting coins for the first time
- Break-in: After a few insertions and removals, the material "settles" and operation becomes significantly smoother The purpose is simply to prevent rattling
Assembly Instructions: COINCORE APEX
Follow these steps to get your APEX Wallet ready for use in minutes
- Preparation: Lay out the printed housing plates, your desired APEX Core and a 30 mm wide elastic band with a length of 26 cm
- Position the band: Fold the elastic band exactly in the middle Pull it through the slot of the back plate about 1/3 from below Make sure the small retaining hooks are on the top side
- Fixing: Fold both ends of the elastic band around the plate and firmly press them against the designated retaining hooks
- Pre-tensioning: Hold the band firmly fixed on the retaining hooks with both fingers and gently stretch the middle tab upwards to prepare the material for the next step
- Invert the band: Place the stretched band over the back plate and then slide the front plate under the elastic band until it sits flush and centered on the setup Then align the band so that it sits centrally and does not wrinkle
- Completion: Slide your desired APEX Core between the two base plates until it sits flush and centered on the setup Your APEX is now ready for use
👍 Free support: A like and a place in your collection show us that the CAD hours were worth it. ☺️
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (10)