Dr. Eggman Articulated Figure (No AMS required)

Important points first:

spaghetti?

If you experience spaghetti, first check the following: clean the build plate, increase the bed temperature by 5-10°, and apply glue as needed. The model has many details, and for multi-color printing, many parts have been split. Some parts are small, which will inevitably increase printing difficulty. The models have all been print-tested, so please don't give a low rating simply because of spaghetti.

Loose connections?

There may be some differences between different filament and depending on printer calibration. For loose connections, you can apply a layer of super glue to the joints. Let it dry completely before reassembling. This can provide extra friction for a tighter fit.

Assembly?

Apply vertical force and support the object as much as possible. Some joints may be tight after assembly; do not force them. Let them sit overnight, then carefully rotate them.

Filament?

Try to use PLA Basic or PETG, and avoid filaments with insufficient layer adhesion like PLA Matte or PLA Silk, as they will break!

Introduction

Finally, Dr. Eggman is here, fully articulated, about 20cm tall. Multi-color, multi-plate printing without AMS. Assembly requires super glue. This is currently the largest model in the series with the most parts. If you encounter any issues, please leave a message, and please do not simply give a low rating. Joint parts might be tight during assembly; in such cases, you can use a blade to shave off some material.

Assembly instructions in PDF are attached below, and you can also view the name of each part through Bambu Studio.

I have also made other things; feel free to check out my homepage if interested.