Ryobi One+ 18v Heat Gun Stand and Trigger Lock

This is for the Ryobi ONE+ 18V cordless heat gun (Model P3150).  This is great tool due to its portability and slow warm up that is great for 3D prints.  But, unlike most corded heat guns it doesn't stand up well on its own, and it doesn't have a trigger lock.  This make working with two hands difficult.  

This is my solution.  

The stand clips into the lanyard slot on the base of the tool and gives a wide platform for balance.

The other three parts combine to make the trigger lock.  It uses and over-center latch to lock the trigger in the on position, and can be released with a flick of your thumb.

    To assemble the lock “snap” the hook into the far lever shaft, and the “snap” the band to front Lever shaft and the latch is complete. (See Pictures)

I used PLA becasue that is what I had in the machine.  PETG would probablly be best but the PLA is working fine.

Shout out to Saul Wright for his great accessory mount for this as well ( makerworld.com/en/models/1112919-ryobi-one-18v-heat-gun-accessory-holder?from=search#profileId-1109812 )

I hope someone else gets as much use of these as I have.

Enjoy!