NBA West Southwest Standings Magnet

https://buymeacoffee.com/mikecamel - If you like what I make and want to help me keep creating, you can buy me a coffee—it’s completely optional and genuinely appreciated. Buying me a coffee helps cover filament and keeps new designs coming.

Hi there again!

Here is the NBA Southwest Standings magnets you can use for your fridge or whiteboard and use them however you like! I think a great thing you can do with this is use this as a personal standings setup and you can adjust as you progress through the season.  The magnets are embedded inside the print, so no need to worry about magnets popping out, especially if you have young kids around.  I also included a "Western Conference" magnet since I know NBA standings normally go by the entire conference.

Since NBA logos are generally much more detailed as compared to the MLB logos I recently made, I enabled ironing and some other settings in Wall Generator and Line Width to make the logos as best as possible with a 0.4 nozzle.

If you printed my MLB magnets, these magnet prints are slightly larger in width as it was needed since some of the NBA logos are larger in width. The magnets are slimmer in depth and the same height as the MLB ones.

There is a little hole on the back (see pics included of the back of the magnet)  of the print I added to help with strength of the magnet, but the magnet will still be held in place.  I added a pause to each print so you can insert a 20x3mm magnet into the print (see pics) and then resume the print. The hole is sized 21x3mm so any 20x3mm magnet should work as far as I'm aware, but I used the link below for my print.  

If you do have any issues with adhesion of the filament sticking to the top of the magnet as it proceeds, I recommend placing the magnet in the print and waiting about 3 minutes or more before resuming so the magnet can heat up from the printer bed.  Also, if you have a glue stick lying around, putting a little glue on top of the magnet and then resuming the print will also help with the filament sticking on its first layer after resuming. I included pics above, but its pretty self explanatory.

Feedback is always welcome!

20x3 mm magnet that I have used - https://www.amazon.com/dp/B09XV978F1?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1