Aqara U200 Keypad Angled / Tilt Adapter 45° Mount

🔐 Aqara U200 Keypad Angled / Tilt Adapter (45° Corner Mount)

Designed specifically for the Aqara U200 Keypad, this angled adapter allows you to mount your keypad cleanly on corners or tight wall edges while keeping it perfectly usable and visible.

✨ Key Features

• True 45° angled design
  Optimised for corner placement so the keypad faces you naturally instead of being hidden on the side.
• Clean, seamless transition
  The adapter smoothly blends from the corner base into the mounting plate – no bulky block look.
• Perfect fit for U200 keypad
  Matches the original footprint precisely for a snug and secure mounting experience.
• Easy removal notch
  Integrated cut-out at the bottom allows you to remove the keypad easily for battery changes.
• Minimal & OEM-like design
  Looks like it belongs there – subtle, clean, and not intrusive.

🧱 Use Case

Ideal for:

• Door frames
• Wall corners
• Tight installation spots where flat mounting doesn’t work
• Improving the usability and viewing angle of the keypad

🖨️ Print Recommendations

• Material: PLA, PETG, ASA, or PA-CF (recommended for durability)
• Layer height: 0.2 mm
• Infill: 20–40%
• Walls: 3–4 perimeters
• Supports: Not required (depending on orientation)

💡 For best strength, print with the flat back side on the build plate.

⚠️ Notes

• Designed for the Aqara U200 keypad only
• Ensure the surface is clean before mounting (adhesive or screws, depending on your setup)
• Slight tolerances may vary depending on your printer calibration