Red Magic 10 Air Cooling Magnetic Full Coverage Phone Case

Red Magic 10 Air Magnetic Cooling Phone Case Manufacturing Instructions (Can be placed flat or stood on its side)

Printing Requirements

1. Prioritize harder printing materials
2. Required dimensions: 165mm×75mm, 0.065mm thick thin metal copper foil, and Ulanzi CM56 magnetic ring
3. Do not enable speed printing throughout the entire printing process

Tools Needed

Alcohol, lighter, utility knife, film squeegee, fine sandpaper

Model Processing Steps

1. Remove model supports; violent disassembly is strictly prohibited
2. Use a utility knife to trim burrs from the model's edges
3. Lightly sand the back panel with fine sandpaper; moderate sanding force is sufficient
4. Apply alcohol evenly to the back panel of the model; do not use too much
5. Ignite the alcohol with a lighter; after the flame extinguishes naturally, let it sit for about ten seconds, then model processing is complete

Assembly Steps

1. Cut the self-adhesive thin copper foil to the corresponding size
2. Paste it onto the model's inner back panel
3. When pasting to the magnetic ring slot, insert the magnetic ring
4. Continue to fully paste the thin copper foil to the bottom to complete the assembly

Optional Beautification Steps

If appearance is a concern, you can cut black cellophane of the same size and paste it over the surface

Below are the purchase links for magnetic rings and copper foil (It is recommended to compare prices across multiple platforms when purchasing):

Self-adhesive copper foil: https://e.tb.cn/h.iQVmDu3yLMsmYjX?tk=siAH5cSGjI9 HU926 

Magnetic ring: https://e.tb.cn/h.i8ksgss3FP0zJn4?tk=C6zR5cSD01C