WKS Śląsk Wrocław

AMS required

height with base: 17.1cm

width: 14.7cm

requires glue for assembly (e.g., superglue)

Since the WKS Śląsk Wrocław logo consists of 6 colors, I have published two profiles:

• The first profile is for printers equipped with two AMS units.
  The logo is printed as a single piece. This version requires significantly less work during assembly.

   

• The second profile is for printers equipped with one AMS unit.
  The logo is printed in three separate parts that need to be glued together. This version requires more time during assembly.

ADDITIONAL NOTES:

The connection of the base to the logo is not symmetrical – check the side before gluing. 

If you are using my profile, just look at the seam running along the back of the logo.

Assembly instructions:

First version:

Glue the model to the base

Second version:

1. Insert the smaller element into the opening of the larger one, as shown in the picture (it should be slightly recessed in the opening).

2. Apply glue to the sides as shown in the picture, then remove the excess. After the glue dries, level the surface so that the inserted element does not protrude above the opening.

4. Glue the shield to the logo

5. Glue the logo to the base

See also:

Football club logos on a stand: https://makerworld.com/en/collections/8437457-football-club-logos-on-the-base 

Polish Football Club Logos: https://makerworld.com/en/collections/22537425-polish-football-club-logos

Car brand keychains: https://makerworld.com/collections/9932381