Magazine Extension for Taurus G3C 9mm

This is an extension for the G3C 9mm magazine that gives additional pinky support.  It prints in two pieces to be superglued together to minimize the need for supports.  Some supports are still required on the body.  I printed this is PETG.  You must use a cyanoacrylate (superglue) with an activator.

In order to install you must push down the spring loaded metal base in the bottom of the mag and slide the extension in place.  It's a bit tricky.  Make sure you slide it until the button engages in the hole to lock it in place.

Feedback welcomed.