Saitek / Logitech Flight Yoke Screw Pad
Print Profile(1)
Description
At some point, I lost the rubber pad from my Saitek flight yoke clamp. I still had the support that clips onto the clamp screw, just not the pad itself. I found a few full-replacement supports on MakerWorld printed in TPU, but I did not like that the load is concentrated at the center of the support, especially since TPU has little structural rigidity.
Since I already had the support, I designed and printed just the rubber pad to clip into it. To my surprise, it worked on the first attempt and fits securely in the existing support.
Also, if you are not using isopropyl alcohol to remove TPU from your build plate, it is worth looking into. It makes removal much easier.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)