Search models, users, collections, and posts
Glasses case
Print Profile(1)
0.12mm layer, 4 walls, 15% infill
Designer
6.4 h
2 plates
Open in Bambu Studio
Boost
1
6
0
0
5
0
Released
Description
I printed them in PLA and PETG, but they can be printed in any material.
Without PLA if the case stays in the car all summer.
The holes for the magnets have a diameter of 10.5 mm and a depth of 1.1mm for the lid and 2.2mm for the base. In the base I put two magnets to make the closure stronger.
For the hinges I used galvanized wire with a diameter of 1.9mm
The model is printed without support.
The support is printed. A canvas is glued on it.
Then a case is put on to protect the lenses
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)