Search models, users, collections, and posts
THE PENETRATOR!! ( filament clip )
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
52 min
2 plates
Open in Bambu Studio
Boost
0
6
0
0
1
2
Released
Description
Is your filament struggling to rotate while drying? Maybe it needs to be PENETRATED!!!
- Push filament in the hole and it will hold tight
- Push the penetrator down in to your filament roll
- DONE!!!
Other filament clips are overly complicated and hard to use. If you need something quick and easy when drying and rotating your filament, or something to use for long term storage if you struggle to put filament through the side of the spool for some reason… GET PENETRATED TODAY!!!
“But why do I need to be penetrated? I normally just stick it in the side”
You may not have noticed, but the spools actually don't rotate very well with filament poking out the side: even if its super snug against the wall the loose filament might still interfere with the roller. Better to get PENETRATED just in case!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)