Bit holder with magnets Milwaukee/Universal

I made a 2 seat bit holder with magnets to secure the Bits (4x2mm magnets Not really a press press fit, needs alittle glue to be on the safe side :)  )

The model have 2 pins to match with the holes in your Milwaukee machine.

I also made a model with NO PINS for other machines that dont have those holes.

The reason I only made space for 2 is because I personaly think they get way to big and clumsy when being more than 2 bit holders.

I rarely need more than 3 types of bits when doing a specific phase on the project. 

Print settings:

No supports needed because they are included in the model (the boxes under the pins), just snap them off

Material: PETG, For heat and impact resistance

Build plate: Smooth (remember to change in 3MF if you have a textured)

Walls: 2

Bottom and top thickness: 1mm

Infill pattern: Honeycomb

Infill %: 25

Magnets go into the slots, They are 4,2mm wide and 1,8mm deep so that a 2mm thick magnet sticks up for best use of the magnets power

Even tho you press them in, put some glue underneath for best results and just to be sure the stay in place