Skadis Holder for VPrint Scraper

This is a holder for VPrint's built plate scraper using Skadis wall storage, found here:

https://makerworld.com/en/models/619927#profileId-543864

No supports needed. The skadis hooks print as a separate piece to maximize strength by having each layer be the whole shape. The hook bar slides (tightly – I gently use a mallet) into the main container body. You will likely not be able to remove the hooks again. If you print the hooks loosely, the container will still work fine, though there may be a little bit of wiggle.

I used PLA, as it should be plenty strong enough for this light task. Your printer and filament may differ from mine, requiring a scale adjustment to the hook part. A Z-axis scale that results in a 0.05 mm change to the part should be enough to raise or lower the tolerance.

There is an angled part on the inside for the front slope of the scraper rest on, leaving the blade not touching the bottom. This should help keep the blade sharp.

Feedback, as always, is appreciated.