07-13 Sierra/Silverado dash center trays

I modified this tray to remove the tape inlays as i could not clean out the supports. I then added a nub on the bottom that lines up with the factory retention holes. These keep it from sliding out and allow for simple removal/re-installation. i also made a mirrored copy for the other side. Printed with tpu for ams and pla supports. this was my first and definitely not last project using pla for tpu support on my p1s. I upped the purge volumes as suggested and have printed a few of these now with no issues. if you have electronic 4x4 dial there is a profile for just the passenger side.