Search models, users, collections, and posts
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
9 min
1 plate
Open in Bambu Studio
Boost
5
7
0
0
6
6
Released
Bill of Materials
Maker's Supply Kits and Parts
Select all
Bambu Filaments
Select all
Description
Boost Me (for free)
Hi there! Excited to share my latest 3D models with you. Download and boost if you like them. Your support helps me keep creating!
Like My Designs? Support My Work with a Coffee ☕
I needed to mount an SSD in and old EliteDesk case. Sadly the original screws were lost in in the fog of time so I was left without any good solution.
I figured I'd put them up here in case anyone else might need them too.
Print 4 of these, add M3x8mm screws through the hole in the middle and fasten to your drive. It will then slide perfectly into place in your case.
Note! These only fit the 2.5 mounting slots.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)