Search models, users, collections, and posts
AAP 01 TDC Wheel for Firewad's Panther Upper
IP Report
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
40 min
2 plates
Open in Bambu Studio
Boost
3
11
0
0
5
2
Released
Description
TDC Wheel for hop up adjustment on the AAP-01 with Firewad's Panther Upper
I'm using it with the original Hop Up chamber with this TDC Mod. I haven't tested other TDC mods or aftermarket chambers, but it will probably work
The wheel can be printed in any sturdy material, but the holder must be printed TPU
The holder hole is just a bit smaller than the wheel shaft, so it won't move accidentaly
Instructions
- Put a screwdriver bit on the wheel. 4mm bit for your chosen screw
- Put the wheel in the holder
- Align the bit with the TDC screw and push the assembly into the panther top slot
- The srew bit can be cut
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)