This is a slim shell to fit the internals of the Tapo C100 camera (except the speaker).

The idea is to be able to fit it in narrower spaces.

All faces are flat so would be easier to make different mounts for it, e.g. for 3d printer, etc.

There are 2 versions:

1. no LEDs - WxHxD - 52.6 x 52.6 x 16.7 mm
2. with LEDs - WxHxD - 52.6 x 52.6 x 19.5 mm

The objective sticks out, is not included in the measurements (obviously...)

The version without LEDs also drops the microphone

The lids are not mix and match!

The lid stays in with friction, OR if you want it more secure, add some M3 screws (up to 10mm)

When inserting the board, put first in its place the area that holds the SD card.

/!\ Might work on Tapo C110, TC60, though I can't guarantee, I don't have those cameras to test.