Search models, users, collections, and posts
FM Mattson 9000 Hot Cold cover kitchen basin mixer
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
26 min
1 plate
Open in Bambu Studio
Boost
3
3
0
0
0
2
Released
Description
´The hot cold plate on FM Mattson kitchen mixer covering the screw for dismantling the mixer fell apart and kept falling out. This resulted in an ugly hole that I needed to fill up with something! Nil desperandum I have a 3D printer and after a couple iterations I ended up with a nice replacement for the original plate. It fits well and tight and will (hopefully) not twist around.
I just used the colors that I had in my AMS so mine are pink for hot and green for cold instead of the usual booring red and blue.
It uses up just over half a gram of PLA so be careful not to print too many!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)